Page History

The number of PTZ devices connected to the Server is specified in the activation license key bundled with INTELLECT™ distribution kit.  

...

1. Go to the Hardware tab in the setting panel of INTELLECT™ (1).

2. Create a PTZ device object under the Telemetry controller object or select the relevant object in the object tree in the Hardware tab of the System settings dialog box (2).

   Image Modified
   

3. Specify the ID, the name of the PTZ device object and select the Telemetry controller object to which the PTZ device is connected (3).

4. Select the ID of the camera equipped with a PTZ device (4).

5. Select the name of the camera equipped with a PTZ device (5).

   Info
   title Note
   Specify either the video camera ID or its name.

   If it is necessary to increase priority of the COM port specified in the settings of the Telemetry controller object, then set the Send commands to local port checkbox checked (6). This parameter is used when commands are sent not to COM port but to video capture card.

   Info

   title	Note.

   This setting is relevant when Stretch video capture cards are in use

6. In the Presets table set checkboxes checked next to the names of presets that are to be displayed on Telemetry control panel (see Telemetry control panel configuration section). Change the preset's name if necessary (6).

   Info
   title Note
   In order to select all presets or cancel this operation, use the Select/Deselect checkbox (7).

7. Set minimal and maximal speed of optical zoom in standard units for PTZ device in the Zooming speed group (8).

8. Set minimal and maximal rotation speed in standard units for PTZ device while mouse control from the Monitor in the Mouse group (9).

9. Set minimal and maximal rotation speed while joystick control in the Joystick group (10)

10. Set minimal and maximal rotation speed of PTZ device in direction of mouse click (Point&Click) in standard units for PTZ device in the Point&Click group (11).

11. Specify the MAC address of the PTZ device in the Address RS-232 address field. The PTZ MAC address corresponds to the address set on the PTZ device with the help of jumpers or configured while programming the PTZ device in the the bundled software (712).

12. Select the zoom increment/decrement speed (zoom ratio) and focusing speed for the camera lens (8). Zoom ratio equals the selected value if zooming is performed in the Video Monitor. The parameter does not affect the digital zoom ratio.

    Selected value is used by default in case the speed was not set in any other way.

    Info
    title Note.
    The digital zoom ratio can be set with the help of tweaki.exe utility – see The Settings panel of the Video subsystem section in Administrator's Guide.

13. In the Presets table set checkboxes checked next to the names of presets that are to be displayed on Telemetry control panel (see Telemetry control panel configuration section). Change the preset's name if necessary (9If the continuous PTZ mode (Continuous Mode) is to be disabled, set the Force disabling continuous PTZ mode checkbox checked (13).

    Info
    title Note.
    If the checkbox is set unchecked, then the continuous PTZ mode is automatically enabled for the PTZ devices that support itIn order to select all presets or cancel this operation, use the Select/Deselect checkbox.

14. To save the changes click the Apply button (1014).