Page History

Selecting the Vehicle

...

Processor operation mode is done in the following way:

1. Go to the Vehicle processor settings panelProcessor object setup panel which is created on the base of the Computer object on the Hardware tab of the System settings dialog box.
   Image Modified

2. To enable the mode of imitating the virtual loop set the Virtual loop checkbox  (1) checkbox. The result of this module operation is retranslating the events of vehicles passing in and out from the detection zone, registered by Vehicle detector module IntelliVision vehicle detection module. On default the events are retranslated without storing in the Vehicle processor database. To enable storing the events to the database, one should perform step 3.

   Info
   title Note.
   Vehicle's speed will be displayed in the Add. info column of the Event viewer interface object if the Virtual loop checkbox is set.

   Image Modified

3. To enable the mode of gathering and storing vehicles information to the Vehicle processorProcessor database set the Collect data checkbox data (2) checkbox .

4. To enable the fixation mode and storing the incidents in the vehicle to the Vehicle processorProcessor database set the Register incidents checkbox (3) checkbox .

   Info
   title Note.
   At the moment of writing the documentation only the Meeting of traffic incidents are fixed.

   
   

5. To enable the mode of vehicles turn's length calculation set the Queue length checkbox. The result of this mode operation is the events registrations with data concerning the length of vehicles' turn. On default events are registered without storing in the Vehicle processor database Processor (4) database. To enable storing the events to the database, one should perform step 3.
6. From the Access: Access (5) dropdown list select the Area object, corresponding to the entrance area to the detection zone where the Length of turn is calculated (5).
7. From the Exit (6) dropdown list select the Area object, corresponding to the exit area from the detection zone where the Length of turn is calculated) (6).
8. Click Apply (7) to save the changes (7).

Selecting the Vehicle processorProcessor operation mode is completed.