Page History

One or several controllers can be connected to the Suprema 2 controller. As a result, the Master-Slave mode is created, where the slave controller acts as a reader, and the Master controller makes the decision to grant access (for details, see the official reference documentation for the system by the Suprema Inc. manufacturer).

The Suprema 2 Slave object slave controller is configured as follows:

1. Go to the Suprema 2 Slave object settings panel. The object is created based on the basis of the Suprema 2 Host object.
   Image Modified
2. In the ID (1) field, specify the identification number of the readercontroller.
3. From the Region In in (2) drop-down list, select the Region corresponding to the area located at side of exit through the reader where the user will be located after entering.

4. From the Region Out out (3) drop-down list, select the Region corresponding to the area located at side of entrance through the reader where the user will be located after exiting.

   Info
   title Note.
   The Region Inin and Region Out are to  Region out fields should be selected if Time &and Attendance interface module is in useused. Otherwise, leave these fields empty.

   
   

5. Configure sending an event upon successful access: Swap pass/granted (4). If the checkbox is cleared, the Pass event is generated, otherwise, the Access granted event is generated.
6. Click the Apply (5)button to save changes (4).

Configuring the Suprema 2 Slave object is slave controller is completed.