Page History

To start generating the report, click the System faults button Image Added.

...

A dialog box then appears, with the parameters necessary for report generation.

Image Modified

This dialog box allows setting the following report parameters:

...

1. Object description. This setting allows switching between the two report modes:
   1. Report on all system objects
   2. Report on one system object
      
2. Region, district and city in which the objects are located. This information is configured on the Control panel - see Editing reference information. If a specific object is selected (see step 1), then these fields are hidden in the report settings window.
3. Failure type. This setting allows specifying the type of fault for which you want to generate a report. You can also create a report for all faults that occurred during a specified interval of time.
   Image Modified
4. Beginning date, End date, Beginning time, and End time. This setting is used for specifying the time range of the alarms by which the report will be generated. 
5. Sorting. A report can be sorted in one of two ways:
   1. By events ("cameras", "archive", etcSignal from vibration sensor, Signal from lock sensor, etc.).
   2. By time of event start.
      
6. Show comment. Set this checkbox if it is necessary to display fault comments in the report (see Processing alarms).
7. After configuring all parameters, click

...

1. OK Image Added.
   The report appears in a new window.
   

Image Removed

The same report, generated for a single object, looks as shown in the figure.

Image Removed

1. Image Added

Each report window has a toolbar.:

Image RemovedImage Added

The Save report and Open report buttons are worthy of special attention. If the ATM Monitoring Reports component cannot access a printer or the report must be saved electronically for later viewing, you can save the report as a file with the .frp, .xls, .xml, .rtf, or .html extension. This file can later be opened on another workstation.