Versions Compared

Old Version 1

changes.mady.by.user Vadim Belyakov

Saved on

compared with

New Version Current

changes.mady.by.user Gleb Matskevich

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

If the transmission of user alarms (see Configuring Configuration for associating events with certain alarm groups section) to the Server of Control is configured, then video data can be added to these alarms. The video data transmission configurations can be created in Monitoring software in order to be added to any events when configuring alarm groups.

Note
titleImportant!
If video data (snapshots or videos) is added to an alarm, then the script for stopping camera recording is to be created (see Sample script for stopping camera recording section).

Configure adding Set up the configurations for transferred video data to alarms as follows:

  1. Go to the settings panel of the Partition of Of Control object. 
    Image Modified
  2. Click the Video data… button. The Adding/Removing configurations for transferred video data box appears.
    Image Modified
  3. To add a new video data transmission configuration click the Add… button. The configuration settings box appears.
  4. In From the Assignment to camera dropdown list drop-down list (1) select the Camera object that will be used for getting video data (1).
  5. Configure the data transmission parameters (2). The data transmission parameters are the same as those for video data transmitted along with sensor alarms (see Configuring sensors section, steps 7-17).
  6. Click the OK button (3). The created configuration is added to the list.
  7. Repeat steps 3-6 for all video data transmission configurations.
  8. Click the OK Apply button.
  9. Click the Apply button.

Video data transmission configurations are now createdSetting up the configurations for transferred video data is complete.