Versions Compared

Old Version 1

changes.mady.by.user Vadim Belyakov

Saved on

compared with

New Version Current

changes.mady.by.user Gleb Matskevich

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

For recognition To ensure the recognition of the state license plates using the VIT software module, it is necessary to make sure that frames with number plates fulfill the following characteristics:

...

install and configure the video cameras in such a way that the following requirements are met:

Camera specifications
Video image
  • The symbols height for IP cameras should be not less than 20-30 px, for analog cameras - not less than 14-20 px, the stroke width should be not less than 2 px;
  • Minimum

...

  • allowed contrast with evenly dirty number plate should not be less than 10% ) contrast differentiation of symbols to the background is 25 on 256 point scale);

...

  • Maximum allowed uneven dirtiness is not more than 12% (ratio of the dirty area of the number plate to its whole area);

...

  • Geometrical proportions of the number plate picture should not differ from such proportions of the number plate itself with more than 10%.

...

Procedure of video cameras setup and mounting for the VIT software module is presented in the vendor documentation.

Info
titleNote.

Vehicles speed at recognition in the Fast mode stated in this document (up to 300 km/h) is provided using special cameras and frame rate more than 25fps. However, in the Auto-Intellect software, frame rate in the Fast mode is fixed at 25fps, therefore speed of vehicles in the Fast mode is limited to 150 km/h in the Auto-Intellect software.

Camera positioning
  • The camera should be installed permanently (for detailed installation information, see the vendor documentation);
Vehicle speed
  • In Slow mode - vehicle speed is no more than 20 km/h

  • In Fast mode - vehicle speed is not more than 150 km/h

Examples of LP images that will be recognized correctly and completely:

Image Added

To ensure the correct recognition of the LP number, its image should not be:

  • unequally lit;
    Image Added
  • overexposed;
    Image Added
  • blurred (due to incorrect shutter speed settings for the speed of the vehicle);
    Image Added
  • distorted (due to incorrect placement of the camera);
    Image Added
  • interlaced;
    Image Added
  • dirty.
    Image Added
Note
titleAttention!

Any deviation from the above requirements reduces the likelihood of correct number recognition

...

.