Page History

It is possible to open the layout with the specified camera.

The View camera macro uses the following algorithm:

1. Searches for the layouts available to the current user that contain the selected camera.
2. Selects the layout with the minimum number of cells to display the selected camera.
3. If the required layout does not exist, creates a new layout with the selected camera.
4. Switches to the selected layout or the created layout.
5. Performs the specified action

...

1. .

To configure the command View camera macro, do as followsthe following:

1. Select a the camera to be displayed (1) .   An implicit selection of a video camera is also allowed - or Camera that initiated command execution .For the Go to (see Configuring filters for event-driven macros). You can select a group of cameras for the Switch to archive mode (see step 2), you can select a group of cameras. 
   Image Removed

   In this software version, you cannot select a group of cameras for this action.

   Note
   Info
   title Note	Attention!
   If the macro was triggered by a sensor or a relay (see Configuring filters for event-driven macros) that are not associated with the camera, the action will not be triggered.

   Image Added

2. Select the display mode (2).

   Display mode	Description
   Select camera	The camera tile is highlighted on the layout.
   Zoom in camera	The camera tile is highlighted on the layout, the viewing tiles take up  tile takes up 98% of the screen.
   Zoom in and show map	The camera tile is highlighted on the layout, the viewing tiles take up  tile takes up 50% of the screen, the map under the tiles tile shows the camera.
   Switch to immersion mode	Immersive mode is on, the viewing tiles take up  tile takes up 50% of the screen.
   Switch to Archive Modearchive mode	The camera window is highlighted on the layout and it is in archive mode.   If a group of cameras is specified, then a layout is created with all the cameras in  in archive mode.

3. Select the user roles, this command applies to (3)

This command uses the following algorithm:

...

1. Mark camera	The camera is added and highlighted on the Marked cameras layout (see Creating special layouts).
   Unmark camera	The camera is deleted from the Marked cameras layout (see Creating special layouts).

   
   

2. Specify the number of the monitor on which the camera should be displayed (3).

3. Select the user roles, for which this macro will be available (4).

The configuration of the View camera macro is complete. 

...