Page History

Selecting To select the Vehicle Processor Processor operation mode is done in , do the following way:

1. Go to the Vehicle Processor object setup settings panel, which is created on the base of the Computer object on the Hardware tab of the System settings dialog box.
   

2. To enable the mode of imitating the virtual loop, set the Virtual loop (1) checkbox. The result of this module mode operation is retranslating the events of vehicles passing in and out from the detection zone, registered by IntelliVision the IV vehicle   detection module module. On By default, the events are retranslated without storing in to the Vehicle processor database. To enable storing the events to the database, one should perform the step 3.

   Info
   title Note.
   Vehicle 's speed will be displayed in the Add. info column of the Event viewer interface object if the Virtual loop checkbox is set.

   Image Modified

3. To enable the mode of gathering collecting and storing vehicles information to the Vehicle Processor database, set the Collect data (2) checkbox .

4. To enable the fixation registration mode and storing the incidents in the vehicle traffic to the Vehicle Processor database, set the Register incidents (3) checkbox .

   Info
   title Note.
   At the moment of writing the documentation, only the Meeting of traffic incidents are fixed.

   To enable the mode of vehicles turn's length calculation set the Queue length checkbox. The result of this mode operation is the events registrations with data concerning the length of vehicles' turn. On default events

   are registered

   without storing in the Vehicle Processor (4) database

   .

   To enable storing the events to the database, one should perform step 3.
5. From the Access (5) dropdown list select the Area object, corresponding to the entrance area to the detection zone where the Length of turn is calculated.
6. From the Exit (6) dropdown list select the Area object, corresponding to the exit area from the detection zone where the Length of turn is calculated).

7. 
   

8. Click the Apply (4) button Click Apply (7) to save the changes.

Selecting the Vehicle Processor operation mode is completed.