Page History

You On the Detectors tab, you can check the triggering of detection tools in the Detection Tools tab.To use this option you must perform the following stepsevents of detectors. To do this, do the following:

1. In the

Detection Tools

2. list of detectors,

highlight the detection tool object whose triggering you need

3. select the detector, which events you want to check.

   Note
   title Attention!
   The

Detection Tool object should

4. detector must be enabled and configured.

Produce
5. Reproduce an event
whose occurrence should trigger the detection tool:
6. upon the occurrence of which the detector must display a frame in the event feed: start of motion in the frame,
turning the video
7. camera rotation,
providing
8. sending sound to an audio device,
etc
9. and so on.

If the

...

detector is configured correctly,

...

frames from the

...

camera

...

that corresponds to the

...

detector are displayed in the event feed, indicating the time they were received

...

.

Image Removed

VMS checks the on/off status of detection tools when they triggered and stopped. Not applicable to detection of: quality loss, position change, disappearance of an object, motion stop and ANPR.  

After the end of triggering, you get the Finished message.  

Image Removed

Image Added
After an event finishes, the Finished caption is displayed below the frame in the event feed.
Image Added
Checking events of a detector is Checking the triggering of a detection tool is now complete.