Page History

General information

This action enables or disables the selected camera, detector, detection tool or input. .

Configuring an action

To configure this action, do as follows:

...

Select the required object (1).

...

the following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. Select a start condition that triggers a macro (see Configuring start conditions).
4. Click the Image Added button below start conditions.
5. From the drop-down list, select Enable or disable component.
6. In the Component parameter, select the required object.
   Image Added
7. In the Enable or disable parameter, select the required operation.
8. Click the Apply Image Added button.

Configuration of the Enable or disable a component action is complete

...

.