Versions Compared

Old Version 2

changes.mady.by.user Gleb Matskevich

Saved on

compared with

New Version Current

changes.mady.by.user Alina Luchkina

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Warning

Axxon Next 4.3.0.8031 and higher versions.

To get the camera events using WebSocket, do the following:

  1. Connect to ws://[user_name]:[password]@[IP-address]:[port]/[prefix]/events.

  2. Send a JSON command to subscribe on events generated by the specified cameras (see Get list of video sources ( cameras and information about them)). This subscription allows you to receive all the events shown in the table below.

    Code Block
    {
"include":
["hosts/Server1/DeviceIpint.1/SourceEndpoint.video:0:0", "hosts/Server1/DeviceIpint.6/SourceEndpoint.video:0:0"],
"exclude":[]
}

    include - – subscribe to the events receiving;
    exclude - – disable the events receiving.

...

Event typeDescriptionStates
devicestatechangedCamera state

signal restored - connected – connected, signal restored

signal lost - signal – signal lost

alertAlarmNo states
alert_stateAlarm stateprocessing - the – the alarm is being processed
closed - alarm – alarm processed
reaction - alarm – alarm initiated
detector_eventDetection tool triggeringNo states
camera_record_state

Archive record state

on - the – the camera is recording to the archive
off - the – the camera is not linked to the archive
gray - the – the camera is linked to the archive, but is not recording

...

Info
titleNote

If the camera is disabled in Axxon Next, no events are received from it using WebSocket, including the signal lost event.

...