Page History

The LPR channel module can operate together with the the Speed traps server module. In this case, each vehicle recognized by the LPR the LPR channel module is compared to the speed value set specified in the Speedthe speed-trap device.

To set up the joint operation of the LPR channel and Speed traps server module, do the following:

1. Go to the settings panel of the  LPR channel object settings panel, corresponding to the activated activated Auto-Uragan,CARMEN AR-Auto or VIT VT program module (see Activating the software module used for identifying the plates).
   Image Added
   
2. Go to the Speed camera settings tab (1).
   Image Removed
3. In the Speed camera settings drop-down list (2), select the Speed traps server object representing the speed-trap device directed at the same lane as the LPR channel camera.

4. In the Synchronization time...ms field (3), enter the time period in milliseconds that it takes the vehicle to drive from the spot of speed detection by the speed-trap device to the viewing zone FOV of the LPR channel recognition video camera.

   Info
   title Note.
   The Synchronization time parameter is needed used to synchronize the operation of the the Speed traps server and module and the LPR channel modules.

   
   

5. Set the Filter events from speed camera checkbox (4) if it is necessary to record only the first speed value detected by the speed-trap device, while other values are ignored until the delay expires or until the LP number is recognized.
6. Click the Apply button (5).

The joint operation of the the LPR channel and Speed traps server modules module is complete.