Page History

To setup configure the Traffic lights detection, do the following:

1. Go to the Traffic lights detection object settings panel, which is created on the basis of the Camera object.
   Image Modified
2. Click the Settings button (1). The Detection settings window will open. 
   Image RemovedImage Added
3. In the Select area tab (1), specify Specify the area of traffic light signals:

   1. Click the Stop video button to capture the video frame (12).

   2. Do the following actions for each traffic light signal:

      • click the button with this signal (23);

      • specify the area of this signal on the captured video frame (4). Click the left mouse button on the video frame and move the cursor holding it.

        Image RemovedImage Added

        Info
        title Note.
        To remove the area click Image Removed opposite , click Image Added next the corresponding button.

        
        

4. Specify the software module parameters:
   
   1. Go to the Parameters Parameters (1) tab.
   2. Specify In the Detection sensitivity [0, 255] field (2), specify the detection sensitivity in conventional units in a the range from 0 to 255 in the corresponding field (1).
      Image RemovedImage Added
   3. In the Periodicity of events occurrence, s field (23), enter the time period (in seconds) between creating messages about the states of traffic light signal.
   4. In the Event type drop-down list (4), select the type of event to be detected: By state change, By period, By period and state change.
   5. Set the Reduce large resolution checkbox if the state of traffic light signal is to be recognized on the frame (35).

5. Click the OK button to save the changes and to return to the settings panel of the Traffic Light Detectionlight detection object (46).

   Info
   title Note.
   Click the Cancel button to return to the settings panel of the Traffic Light Detectionlight detection object without saving the changes (5).

   
   

6. Click the Apply button (2).

Setting up Configuring the Traffic Light Detectionlight detection software module is completed.