Page History

To configure the Sigur ACS access points, do the following:

1. Go to

...

1. the settings panel of the

...

1.  Sigur access point object

...

1. , which is created on the

...

1. basis of the

...

1. Sigur server object in the Hardware tab of the System settings dialog box.
   Image Modified

The Access point object is registered automatically when reading Sphinx ACS configuration.

The following parameters are automatically specified when reading Sphinx ACS configuration:

1. Access point ID in the Sphinx ACS database (1);
   Image Removed
2. access point configuration (2);

   In the ID field (1), enter the access point number on the Sigur server.

   Info
   title Note.
   The Configuration field (2) displays the access point configuration, which is set  Access point configuration is set using the switch on the card of corresponding Sphinx the corresponding Sigur ACS controller (see reference documentation about Sphinx ACS) .

   
   

3. access control mode From the Type of access point drop-down list (3).

Sphinx ACS access points are configured as follows:

1. , select the type of access point managed by the controller:
   
   • Barrier;
   • Door;
   • Gate;
   • NFC terminal;
   • Turnstile.
2. From the Entrance drop-down list (4), In the Entry dropdown list select the Region object corresponding to the area on the side of exit from the access point (4).
3. In From the Exit dropdown list drop-down list (5), select the Region object corresponding to the area on the side of entrance to the access point (5).
4. Set parameters of the access control parameters at entrance and exit (6):

   1. From the Entrance and Exit drop-down lists, select the decision-making side for granting access:

      1. Intellect decides - access decision is automatically made by ACFA-Intellect.

      2. Operator decides - access decision is made by the operator.

      In the Entry dropdown list select the one that will decide whether to give access or not and whether to register it or not – Intellect Server or operator;

      1. Info
         title Note.
         To process the request operator is to create a Photo ID interface object and configure it for the Operator’s query (Access granted) event. For more information about this object and its functions, please refer to Photo ID User Guide.

         
         

   2. If it is considered that passing is performed just after placing Set the Don’t wait access cycle for entry and Don’t wait access cycle for exit checkboxes if it is necessary to record the passage immediately after placing the access card to the reader, then check the Don’t wait access cycle for exit checkbox. If the passing passage is considered to be performed only after passing the access point (i.e. door sensor is triggered), uncheck unset this checkbox.
   Set parameters of access control at exit (7)
   1. .
   The parameters are the same as those of access control at entrance (see the previous item).
5. Click the Apply button to save all changes (87).
6. Repeat steps 1-9 for all required Sphinx ACS access points. 

Sphinx ACS access points are Sigur ACS access points are now configured.