Versions Compared

Old Version 3

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version Current

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

General information

This action allows you Use this action to transmit audio from the Clientclient's microphone to the selected speaker.

Note
titleAttention!

If a Client the client is behind the NAT, you have to must specify the external IP address of the switch for this Client with and a port range of at least 1000 ports on the client (see see Network settings utility).

Configuring an action

To configure this action, do as followsthe following:

  1. Go to the Programming tab.
  2. In the Event rules or Cycle rules list, click Create... (see Configuring
    3. Configure the conditions to start a macro (see Configuring filters for event-driven
  3. macros).
  4. Select a start condition that triggers a
    5. speaker (1).
    Image Removed
  5. Select a microphone (2).
  6. Specify sensitivity from 0 to 100 (3).

To stop sound, use the Stop voice notification from client command on the Client.

  1. macro (see Configuring start conditions).
  2. Click the Image Added button below start conditions.
  3. From the drop-down list, select Voice notification from сlient.
  4. In the Speaker parameter, select the corresponding speaker.
    Image Added
  5. In the Microphone parameter, select a microphone.
  6. In the Sensitivity parameter, specify the microphone sensitivity for audio transmission from 0 to 100.
  7. Click the Apply Image Added button.

Configuration of the Voice notification from сlient action is complete.To configure this command, select a speaker (4) and a microphone (5).