Page History

To setup configure the Traffic lights detection, do the following:

1. Go to the Traffic lights detection object settings panel, which is created on the basis of the Camera object.
   
2. Click the Settings button (1). The Detection settings window will open. 
   
3. to In the Select area tab (1), specify the area of traffic light signals:

   1. Click the Stop video button to capture the video frame (2).

   2. Do the following actions for each traffic light signal:

      • click the button with this signal (3);

      • specify the area of this signal on the captured video frame (4). Click the left mouse button on the video frame and move the cursor holding it.

        

        Info
        title Note.
        To remove the area, click  opposite  next the corresponding button.

        
        

4. Specify the software module parameters:
   
   1. Go to the Parameters (1) tab.
   2. In the Detection sensitivity [0, 255] field (2), specify the detection sensitivity in conventional units in a the range from 0 to 255.
      
   3. In the Periodicity of events occurrence, s field (3), enter the time period (in seconds) between creating messages about the states of traffic light signal.
   4. In the Event type drop-down list (4), select the type of event to be detected: By state change, By period, By period and ctate state change.
   5. Set the Reduce large resolution checkbox if the state of traffic light signal is to be recognized on the frame (5).

5. Click the OK button to save the changes and to return to the settings panel of the Traffic light detection object (6).

   Info
   title Note.
   Click the Cancel button to return to the settings panel of the Traffic light detection object without saving the changes.

   
   

6. Click the Apply button (2).

Setting up Configuring the Traffic light detection software module is completed.