List of Additional workplaces

If only ATM Monitoring and ATM Monitoring reports interfaces are to be in use on Additional workplaces, then there is no need to configure the list of Additional workplaces. If the Search in archive interface is to be in use, then on the ATM-Intellect Workstation specify the list of Additional workplaces that are going to use this interface by specifying the computer name and client code.

The client code is bound to the computer. You can find it out as follows:

1. Open the Search in archive interface in the Additional workplace configuration where the Search in archive component is to be used on the computer with installed Monitoring software. 
   
2. Click the Settings button in the bottom left corner.
3. The client code is specified in the appeared Settings box.
   

The list of Additional workplaces that can be connected to the ATM-Intellect Workstation is configured as follows:

1. Go to the settings panel of the ATM-Intellect Workstation object. 
   
2. Click the Monitoring… button. As a result the box of configuring the list of Additional workplaces appears. 
   
3. To add an Additional workplace to the list click the Add… button.
4. In the appeared box specify the computer name on which the Additional workplace is installed (1). 
   
5. Specify the client code in the Client code field (2).
6. Click the OK button(3).

7. Repeat steps 3-6 for all Additional workplaces that will be connected to this ATM-Intellect Workstation.

   Note.

   To edit specified settings select the Additional workplace in the list and click the Edit… button.
   To delete the Additional workplace in the list select it in the list and click the Delete button.
8. Click the OK button.
9. Click the Apply button.

The list of Additional workplaces is now configured.