Previous page Next page


Setting up the TREZOR-M receiver is performed in the following way:

  1. Go to the Trezor M receiver (Trezor) object settings created on the base of the Bus RS-485 (Trezor).

  2. For the Address parameter (1), specify the address of the connected receiver (from 0 to 255).

    Note

    The Address with a ‘0’ value (or ‘00000000’ in binary code) is meant for executing utility functions.

    The receiver address is set up with the eight-bit switch on the receiver circuit plate.

  3. For the crossSpeed parameter (2), specify the speed at which the trespasser intersects the detection zone.
  4. For the frequencyChannel parameter (3), specify the frequency character of the receiver.
  5. For the Threshold parameter (4), specify the receiver threshold.
  6. Click Apply (5).

The TREZOR-M receiver is configured.

  • No labels