Configuring the Dahua door

To configure the Dahua door, do the following:

Go to the settings panel of the Dahua Door object that is created on the basis of the Dahua Access Controller object.
From the Number drop-down list, select the number of the Dahua door.
From the Entry to drop-down list, select the area corresponding to the territory on the exit side of the door.
From the Exit from drop-down list, select the area corresponding to the territory on the entry side of the door.
Click the Read settings button to read the configuration from the Dahua controller/terminal.
Click the Write settings button to write the configuration to the Dahua controller/terminal.
In the Open timeout (ms) field, specify in milliseconds for how long the Dahua door will be opened. The default value is 2000 ms.
In the Close timeout (s) field, specify in seconds the time after which the opened door will close. The default value is 60 s.
From the Open timezone drop-down list, select which timezone will be opened.
From the Close timezone drop-down list, select which timezone will be closed.
By default, remote verification is disabled. To enable it, set the Remote verification checkbox.
From the Remote verification timezone drop-down list, select a remote verification timezone.
From the Access type drop-down list, select the required access type. The default value is PIN or card.
In the Control section, select the events that you want to monitor by setting the checkboxes next to them: APB, Not locked by guard, Duress entry, Sensor, Break in, Malicious open. By default, the following events are monitored: Duress entry, Sensor, Break in, Malicious open. Other events aren’t monitored.
From the Access status drop-down list, select the access status for the Dahua door: Normal (default), Always closed, Always open.
Click the Apply button to save the settings.

Note

The supported settings of the Dahua terminal/controller door depend on the device features (see manufacturer's documentation).

Page tree

Documentation for ACFA PSIM 1.3.