Setting up HoneyWell N-1000 access point parameters

Setting up access point parameters is carried out on setting panel of N1000 door object. This object is created on the basis of N1000 panel object on Hardware tab of System settings dialog box.

Setting up access point parameters is carried out the following way:

1. Go to setting panel of N1000 door object.
   
2. In Door number set access point address (1).
3. From Exit: dropdown list select Region object that corresponds to the territory located on the side of reader’s entrance (2).
4. From Enter: dropdown list select Region object that corresponds to the territory located on the side of reader’s exit (3).
5. Click Apply in order to save changes (4).

Setting up access point parameters is completed.