Documentation for Axxon PSIM 2.0. Documentation for other versions of PSIM is available too.

Previous page Next page


To initiate recording by audio trigger, you must arm the microphone. To arm the microphone, select it in the microphone list and click .

When you arm the microphone and its signal level is less than the threshold level of audio trigger, the microphone status indicator turns yellow.

When you arm the microphone (or at any time after arming) and its signal level exceeds the threshold level of audio trigger, recording is initiated (the ACCU_START event is received from the microphone, and asterisks appear to the right of the Volume level slider on the settings panel of the Microphone object), and the microphone status indicator turns red.

The recording continues as long as the microphone signal level exceeds the threshold level of audio trigger. If the microphone signal level decreases below the threshold level of audio trigger, the recording stops (the ACCU_STOP event is received from the microphone, and asterisks disappear to the right of the Volume level slider on the settings panel of the Microphone object ), and the microphone status indicator turns yellow.

To disarm the microphone and stop recording, click the button.

Note

The buttons are used to control recording from the microphone both by the Operator's command and by audio trigger. Selection of recording mode depends on the program settings.

For more information on setting up the audio trigger recording of the Microphone object, see Setting up the audio trigger recording.