Configuring the checkbox

Configure the checkboxes as follows:

1. On the Logic tab, select the element in the table and click the Edit button.
   
2. If necessary, in the Step description field (1), enter the text that will be displayed in the column to the left next to the element.
   
   

3. From the Number of elements list (2), select the required number of checkboxes.

   Note

   The maximum number of elements is determined by the possible number of columns when you display the logic (see Configuring the display of logic).

4. In the Element name fields (3), enter the names of the checkboxes.
5. From the Number of conditions list (4), select the number of different logics used to proceed the event handling. In this case, each logic implies a certain set of checkboxes that the operator set. For each such set of checkboxes, you can set the next element to display.
6. If you want to display the same element at any possible values ​​of the checkboxes, set up this element in the Logic group (5). If you use several logics, set up each logic settings in the Logic [N] group (6), where N is the logic number. To set it up, do the following:
   1. In the Conditional transition field, select the element that must be displayed next.
   2. If you also want to execute a macro, select it from the Macro list.
   3. Set the values of each checkbox, at which the above actions will be performed.
7. Click the OK button.

Example of displaying the Checkbox element:

Configuring the Checkbox element is complete.