To configure the Gate Parking controller, do the following:

1. Go to the Gate Parking access point object’s settings panel.
   
2. Set the APB control checkbox to activate the antipassback (1).
3. Set the FreeLogic mode checkbox to activate the reactions mode on which the controller can enable and disable exits when some specified events appear inside of controller (2).
4. Set the Do not poll checkbox to lock receiving of events from controller (3).
5. From the Entrance to: drop-down list select the Region object corresponding to the area located in the site of exit through the reader (4).
6. From the Exit from: drop-down list select the Region object corresponding to the area located on the site of entry through the reader (5).
7. Configure the lock parameters for passes on entry and exit ( 6):

   1. From the Relay time: drop-down list select the time period in seconds during which the lock will be opened.

      If the relay time equal to 0 the lock is failed to open by available ways: using the key, button or corresponding command.

   2. From the Access time: drop-down list select the time period in seconds during which the user can open the door.

      Access time and relay time start to count off from the moment of relay trigerring (i.e. lock opening), so the access time can’t be less than relay time.

   3. From the Time of holding open: drop-down list select the time period in seconds after door opening during which the door is to be closed.

      If the door will not be closed after time of holding open expire then the Door not closed events is fixed. It is followed by signal and light indication till the door will be closed.

   4. From the Confirmation time: drop-down list select the time period in seconds during which access is to be confirmed by card (see Configuring Gate Parking access modes section).

      If the confirmation time is 0 the confirmation timeout is not limited.

8. Configure time zones in case of users have access level with time zone different from Always and Never. For each time zone of Gate Parking controller select the time zone of the ACFA Intellect software from the corresponding drop-down list.
   
9. Click the Apply button.

Configuring parameters of the Gate Parking controller is completed.