Rus

To set up the Vehicle tracer interface window do the following:

  1. Go to the Vehicle tracer settings panel.
  2. Click Settings... button. The Settings dialog window will open in result.

  3. In the Number of events in protocol field (1) enter the maximum number of events that may be displayed in every protocol of the Active monitor component. Updating the protocol, containing the maximum number of events, is performed in a loop: while adding a new event the earlier is deleted.

    The question is about two protocols (see the document The Auto-Intellect Software Package: Operator's Guide):

    1. The protocol of identified vehicles, containing data about the identified vehicles;
    2. The alarms protocol, containing data about the vehicles, for which alarms have been registered.
  4. Set the Speed switch (2) to the position, corresponding to the Vehicle's speed unit of measurement. That is to be displayed in the Vehicle tracer window (km/h or m/h).
  5. On default in the Active monitor  events protocol there are displayed the following data for every vehicle:
    1. Video frame;
    2. Identified plate;
    3. Speed;
    4. Plate's recognized;
    5. Date and time of receiving the data;
    6. Alarm's reason (only for alarms).
      In case if in the Active monitor events protocol there should be displayed only identified number, name of plate's recognizer, and data and time of receiving the data for every event, set the Reduced view of protocol checkbox (3).
  6. There is possibility to create additional Active monitor components (see the document The Auto-Intellect Software Package: Operator's Guide»). In case if the alarms protocol is displayed only in the main interface component Active monitor, not in the additional ones, set the Protocol of alarms only in main Active Monitor window checkbox (4).
  7. On default the number of active monitor additional displayed components is not restricted. In case if only one, last created active monitor component is required to be displayed, set the Only one additional window active monitor checkbox (5).

  8. Click OK to save the changes and close the Settings dialog window (6).

    Click Cancel to close the Settings dialog window without saving the changes (7).

    The interface settings of the window Vehicle tracer are completed.