To set up the Vehicle Tracker interface window, do the following:

  1. Go to the Vehicle Tracker settings panel.
  2. Click the Settings button. The Settings dialog window will open.

  3. In the Number of events in protocol field (1) enter the maximum number of events that may be displayed in every protocol of the Active monitor component. The update of the protocol which contains the maximum number of events, is performed in a loop: when a new event is added, the oldest is deleted.

    That entails two protocols (see Auto-Intellect Software Package: Operator's Guide):

    1. The protocol of identified vehicles, containing data about the identified vehicles;
    2. The alarms protocol, containing data about the vehicles, for which alarms have been registered.


  4. Set the Speed switch (2) to the position, corresponding to the Vehicle's speed unit of measurement. That is to be displayed in the Vehicle Tracker window (km/h or m/h).
  5. By default, in the Active monitor  events protocol the following data for every vehicle is displayed:
    1. Video frame;
    2. Identified LP number;
    3. Speed;
    4. Name of LP recognizer;
    5. Date and time of receiving the data;
    6. Reason of alarm (only for alarms).
      In case only the identified LP number, name of LP recognizer, and date and time of receiving the data should be displayed for each event in the Active monitor events protocol, check the Reduced view of protocol checkbox (3).
  6. You can create additional Active monitor components (see The Auto-Intellect Software Package: Operator's Guide). If the alarms protocol should be displayed only in the main interface component of Active monitor and not in the additional ones, check the Protocol of alarms only in main Active Monitor window checkbox (4).
  7. By default, the number of additional Active monitor components to be displayed is not restricted. If only the most recent additional Active monitor component should be displayed, check the Only one additional window active monitor checkbox (5).

  8. Click OK to save the changes and close the Settings dialog window (6).

    Click Cancel to close the Settings dialog window without saving the changes (7).

    The interface settings of the Vehicle Tracker window are completed.