The LPR channel module can operate together with the Speed traps server module. In this case, each vehicle recognized by the LPR channel module is compared to the speed value set specified in the Speed-trap device.

To set up the joint operation of the LPR channel and Speed traps server, do the following:

1. Go to the LPR channel object settings panel, corresponding to the activated Auto-Uragan, CARMEN-Auto or VIT program module (see Activating the software module used for identifying the plates).
2. Go to the Speed camera settings tab (1).
   
3. In the Speed camera settings drop-down list (2), select the Speed traps server object representing the speed-trap device directed at the same lane as the LPR channel camera.

4. In the Synchronization time field (3), enter the time period in milliseconds that it takes the vehicle to drive from the spot of speed detection by the speed-trap to the viewing zone of the LPR channel recognition video camera.

   Synchronization time is needed to synchronize the operation of the Speed traps server and the LPR channel modules.

   
   

5. Set the Filter events from speed camera checkbox (4) if it is necessary to record only the first speed value detected by the speed-trap device, while other values are ignored until the delay expires or until the LP number is recognized.
6. Click Apply (5).

The joint operation of the LPR channel and Speed traps server modules is complete.