The POS process system object is created on the basis of the Computer object on the Hardware tab of the System setting dialog box.  

To configure the POS process system object, do the following:

1. Go to the settings panel of the POS process object.
   
2. The POS terminal objects created in the objects tree are listed in the Available POS terminals list (1).

3. Move the required terminals to the Selected POS terminals (2) using the and buttons. The information from selected terminals will be used to count the occurrence of the specified parameter.

   To move the POS terminals from the Selected POS terminals list to the Available POS terminals list, use the  and  buttons.

   
   

4. In the Parameter name field, enter the name of the parameter, the number of the same values of which should be monitored (3). The parameter name depends on the characteristics of the protocol used by the terminal.
5. In the Maximal number field, enter the maximum number of occurrence of the same values of the parameter (4).

6. In the Additional information field, enter the events description which will be included in the event description next to the card number and number of repetitions (5).
    

   In the example displayed in the figure, the description of alarm messages will be presented as «Some information 3x123», where 123 is a card number, 3 is a number of times when the parameter appeared.

   
   

7. From the Clear counter by time zone activation drop-down list, select the Time zone object corresponding to the time period, the start of which indicates the necessity to reset the counter of parameter occurrence (6).
    

   The Time zone objects are created and configured on the Programming tab of the System setting dialog box. For more information about creating and configuring the time zone, see Intellect software package. Administrator’s Guide.

   
   

8. Click the Apply button (7).

Configuration of the POS process system object is completed.