To configure the input monitor interface (V200), do the following:

  1. Go to the Input monitor interface (V200) object's setup panel, which is created on the basis of the VertX V1000 Network Controller object.
  2. If the tamper switch is enabled, set the Tamper switch enabled checkbox (1) and configure the tamper switch A/D limits (see Configuring EEPROM Limits).
  3. In the Tamper switch debounce time, msec field, enter the time period (in milliseconds) to be used for fixing (debouncing) the bouncing tamper switch signal (2).
  4. If the AC failure input is enabled, set the AC failure input enabled checkbox (3) and configure the AC failure A/D limits (see Configuring EEPROM Limits).
  5. In the AC failure input debounce time, msec field, enter the time period (in milliseconds) to be used for fixing (debouncing) the bouncing AC failure input signal (4).
  6. If the battery failure input is enabled, set the Battery failure input enabled checkbox (5) and configure the battery failure A/D limits (see Configuring EEPROM Limits).
  7. In the Battery failure debounce time, msec field, enter the time period (in milliseconds) to be used for fixing (debouncing) the bouncing battery failure input signal (6).
  8. Set the checkboxes next to those service inputs, when changing the states of which the corresponding events will be generated (7) (see Configuring automatic generation of HID events).

  9. In the Address drop-down list, select the interface module's address (8).

    The device's address is set automatically when the object tree is created. Changing the address may lead to losing the connection to the device.


  10. If reset switch is enabled, set the Reset switch enabled checkbox (9) and configure the limits for resetting the switch (see Configuring EEPROM Limits).
  11. Click Apply to save the changes (10).

The input monitor interface (V200) is now configured.