This opens the relevant layout and map with the camera marked on it.

To configure the command, do as follows:

1. Select a camera to be displayed (1). An implicit selection of a video camera is also allowed - Camera that initiated command execution.

   

   For the Go to archive mode mode (see step 2), you can select a group of cameras. In this case, if the launch of the macro command was caused by the triggering of a sensor or relay (see Configuring filters for event-driven macros) that are not associated with any video camera, the action will not be launched.

2. Select the display mode (2).

   Display mode	Description
   Select camera	The camera tile is highlighted on the layout.
   Zoom in camera	The camera tile is highlighted on the layout, the viewing tiles take up 98% of the screen.
   Zoom in and show map	The camera tile is highlighted on the layout, the viewing tiles take up 50% of the screen, the map under the tiles shows the camera.
   Go to immersion mode	Immersive mode, the viewing tiles take up 50% of the screen.
   Go to Archive Mode	The camera window is highlighted on the layout and it is in archive mode. If a group of cameras is specified, then a layout is created with all the cameras in archive mode.

   
   

3. Specify the number of the monitor on which the camera should be displayed (3).

4. Select the user roles, this command applies to (4).

This command uses the following algorithm:

1. The system searches for layouts that contain the specified video camera and are accessible to the user.
2. The system chooses the layout with the minimum number of cells to display the selected video camera.
3. If the required layout does not yet exist, the system creates a new layout with a single video camera.
4. The system switches to the selected layout.

5. The specified process is running.