To add a Suprema 2 face template in the Access Manager module, do the following:

1. Go to adding biometric data in the Access Manager window (see Adding biometric parameters).
2. Select the extension (Edit Face) Suprema 2 Host that corresponds to the controller with the biometric face reader connected to it, or to the terminal.
3. The Suprema. Capture face dialog box will open. To add a new face template, click the Add button.
   
   The Suprema. Capture face window will open.
   
   

4. From the Threshold drop-down list (1), select the sensitivity for capturing a face image: from 0 (low) to 8 (maximum).

5. To start capturing, click the Capture button (2) and then follow the instructions displayed at the top of the Suprema. Capture face window. In case of successful face capture, the resulting photo will be displayed, and the template of this photo will be saved.
   

   Arbitrary photos (from files, cameras) cannot be sent to the terminals. If there are many terminals, you can capture a face from any of them. Then this image will be sent to other terminals with different access attributes.

   
   

6. Set the Set as person’s photo checkbox (3) to assign the face captured by the terminal as the user photo.

7. Click the OK button to complete adding a face template. Click the Cancel button to cancel the operation. 

8. To delete a face template, select it in the list of templates and click the Remove button.

   To delete all face templates, click the Remove all button.

   
   

9. Click the OK button to save the face template.

Adding the Suprema 2 face template in the Access Manager module is completed.