To configure the MicroWave 330 radio beam sensor control go to the settings panel of the Model 330 object. This object is created on the basis of the Model 330 object on the Hardware tab of the System settings dialog window.

To configure the MicroWave 330 radio beam sensor control, do the following:

1. Go to the Model 330 object’s settings panel.
   

2. The value specified while auto creating the objects tree is set In the Address drop-down list (1). To change the MicroWave 330 address, select the new value from the Address drop-down list.

   Information about the MicroWave 330 is specified in the MAC address and Installation name fields. Check the accuracy of MicroWave 330 address if these fields are empty (2).

   
   

3. In the Alarm fix cause table (3) specify up to 10 alarm descriptions, one of which can be selected by an operator when processing the alarm of a MicroWave 330 radio beam sensor control on the map (see Managing MicroWave 330).
4. Click Apply button (4).

Configuring the MicroWave 330 radio beam sensor control is completed.