To configure the Optex Sensor, do the following:

1. Go to the Optex Sensor object settings panel, which is created on the basis of the Optex object.
   

2. In the IP address field, enter the sensor's IP address (1).

   This IP address can be found in the vendor documentation.

   
   

3. In the Ethernet port field, enter the sensor's communication port (2).

   By default, 1234 is used.

   
   

4. In the Protocol type drop-down list, select the communication protocol to be used to talk to the sensor (TCP or UDP) (3).

5. Set the Sensor disarmed check box (4) to automatically stop the alarm when the zone exits the Alarm state by hardware. Otherwise, the alarm will be active until the operator processes it.

   The alarm processing method is the same for all areas belonging to one sensor.

   
   

6. Click Apply to save the changes (5).

Optex Sensor is now configured.