The SADP settings of the Hikvision controller will be illustrated by an example of the Hikvision 26X controller. SADP settings for other Hikvision controllers are similar.

To configure the Hikvision SADP, do as follows:

  1. Go to the Hikvision 26X object configuration panel.
  2. Press the SADP Operations button. The SADP Settings Setup window opens.
  3. In the Password field (1), enter a new password for the Hikvision controller.
  4. Check the Overwrite Password in Intellect (2) box to automatically overwrite the old password in the ACFA Intellect integration module with the new one; otherwise you need to do it manually (refer to Network settings of the Hikvision controller).
  5. Check the Activate (3) box to activate the controller in case it has been reset to factory settings. The password entered on step 3 becomes the master password for the Hikvision controller.
  6. Check the Setup Network Parameters (4) box to enable changing network settings.
  7. Check the DHCP box (5) to enable DHCP.
  8. In the IP address field (6), enter the new IP address of the Hikvision controller.
  9. In the Port field (7), enter a new connection port number for the Hikvision controller.
  10. In the Subnet mask field (8), specify the mask for a subnet where the Hikvision controller will be located.
  11. In the Gateway field (9), specify the connection gateway for the Hikvision controller.
  12. Check the Overwrite IP Settings in Intellect box (10) to automatically overwrite the old network settings in the ACFA Intellect integration module; otherwise you need to do it manually (refer to Network settings of the Hikvision controller).
  13. Click the OK button to apply the settings.

Hikvision SADP settings are now configured.