Configuring the Suprema 2 controller

The Suprema 2 controller is configured as follows:

1. Go to the Suprema 2 Host object settings panel. The object is created based on the Suprema BiometricalACS v2 object.
   
2. In the Address (1) field, set the IP-address of the Suprema 2 controller.
3. In the Port (2) field, set the port of the Suprema 2 controller.
4. In the ID (3) field, specify the identification number of the controller connected via Ethernet.
5. From the Region in (8) drop-down list, select the Region corresponding to the area located at side of exit through the reader.

6. From the Region out (9) drop-down list, select the Region corresponding to the area located at side of entrance through the reader.

   Note.

   The Region in and Region out are to be selected if Time&Attendance interface module is in use. Otherwise, leave these fields empty.

7. Click Write Users (6) to send users to the controller.
8. Click Set Time (7) to synchronize controller time with Server time.
9. Enable controller options:
   1. Set the Support Pin (8) check box if the controller supports authorization by password.
   2. Set the Support Card (9) check box if the controller supports authorization by card.

   3. Set the Support Fingerprint (10) check box if the controller supports authorization by fingerprint.

   4. Set the Support Face (11) check box if the controller supports authorization by face.

      Note.

      Only set the check boxes for options supported by the Suprema 2 controller.

10. Click Read Options (12) to read supported options from the controller.
11. Click Synchronize devices tree (13) to automatically create objects in ACFA Intellect hardware tree according to the devices connected to the controller.
12. Click Apply to save changes (14).

Configuring the Suprema 2 controller is completed.