Configure the MicroTrack II control segment

To configure the MicroTrack II control segment go to the settings panel of the MicroTrack II Segment object. This object is created on the basis of the MicroTrack II object on the Hardware tab of the System settings dialog window.

To configure the MicroTrack II control segment, do the following:

1. Go to the MicroTrack II Segment object’s settings panel.
   
2. In the Beginning: field using up-down buttons enter the number of subcell corresponding to the key point in which the control segment started (1).

3. In the End: field using up-down buttons enter the number of subcell corresponding to the key point in which the control segment finished (2).

   Note.

   The range of values of Beginning and End fields is from 0 to 215. It is not recommended to cross control segments.

   Attention!

   Value in the End field should not exceed the value in the Beginning field.
4. In the Control AIM: select an AIM security detector, which the trigger the alarm at a given interval.
5. In the Timeout: set the interval, after which the alaram will be activated. 
6. Click Apply button.

Configuring the MicroTrack II control segment is completed.