Documentation for Axxon Next 3.6.4. Documentation for other versions of Axxon Next is [available too].

Previous page Next page

Attention!

Relays can be switched only in one direction: from normal condition to active.

To configure the switching of a relay when a detection tool is triggered, you must perform the following steps:

  1. Add the Switch relay rule (see Adding an automatic rule). 
  2. In the Switching relay list (1), select the Relay object corresponding to the relay which needs to be switched when the detection tool is triggered. Any enabled relay in the system can be used, including one tied to another server.
  3. In the At field (2), enter the length of time for which the relay should be in switched status.
  4. To save changes, click the Apply button.

Configuration of switching a relay when a detection tool is triggered is now complete.