The settings panel of the PTZ section

The PTZ section is used for setting the telemetry control elements.

The settings panel of the PTZ section is shown in the figure.

The setting parameters of the PTZ section are described in the table.

No	Parameter name	The way of specifying the parameter value	Parameter description	Representation	Default value	Range of values
1	The Delay between commands (ms) field	Enter the value in the field	Sets the delay time between the execution of the PTZ device control commands. This parameter isn't used for IP cameras	ms	250	No limitations. We don't recommend changing the default value
2	The Delay by priority (ms) field	Enter the value in the field	Sets the delay time between switching from the PTZ control to the interface, which has a priority that is lower or equal to the priority that controls at the current moment	ms	30000	No limitations. We don't recommend changing the default value
The Joystick group
3	The Sensitivity [1, 10] field	Enter the value in the field	Sets the joystick sensitivity: the lower the value, the greater the sensitivity. If the value of the parameter is low, the camera reacts to small joystick deviations. If value of the parameter is high, the camera stays motionless until the significant joystick deviation	Sensitivity in conditional units	5	1—10

Page tree