Documentation for Intellect 4.10.4. Documentation for other versions of Intellect is available too.

Previous page Backup archive monitoring  Automated copying Next page


Manual copying uses the Monitoring (1) tab.

Manual copying can be started and stopped using the Start (2) and Stop (3) buttons, correspondingly. Elements for setting time intervals for copying recordings of all available cameras can be found to the left of the copying controls (4).
To start copying, the following steps should be performed:

  1. Set date and time to start and stop copying. If the start and stop date and time for copying are not identified, all recordings from the pre-defined cameras will be copied to the Backup archive.
  2. Select the cameras, whose recordings will be copied. To select cameras, check the corresponding boxes (5). In addition, the Select all (6) checkbox is used to select (or cancel the selection) all cameras in the table concurrently.
  3. Initiate copying by clicking Start. After a short delay,  appears to confirm that recordings of the selected cameras are now copying.
  4. To stop copying, click Stop.

Note.

Copying may be significantly delayed after Start has been pressed.