Configuring macros when working with ANPR lists

When you are working with ANPR list, you can configure the macros to trigger on the following events:

• if the target  number shows up in the selected ANPR list;
• if the target  number does not show up in the selected ANPR list;
• recognition of a specific number from the selected ANPR list;
• if the target  number does not show up in all available ANPR lists;
• recognition of any number from any ANPR list.

Target number shows up in the selected ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions in the License plate recognition list and select the required ANPR list (1).
   
2. Leave the field 2 empty.
3. The status of the Presence toggle (3).

The target number does not show up in the selected ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions in the License plate recognition list and select the required ANPR list (1).
   
2. Leave the field 2 empty.
3. The status of the Absence toggle (3).

Recognition of a specific number from the selected ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions in the License plate recognition list and select the required ANPR list (1).
   

2. Select a specific number plate in field 2.
   

   Note

   To select another number, clear the 2 field and re-open the list.

3. The status of the Presence toggle (3).

The target  number does not show up in all available ANPR lists

In this case, configure the macro as follows:

1. Go to the Start conditions field in the License plate recognition list and select  Not listed (1).
   
   
2. Leave the field 2 empty.
3. The status of the Presence toggle (3).

Recognition of any number from any ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions field in the License plate recognition list and select  Not listed (1).
   
   
2. Leave the field 2 empty.
3. The status of the Absence toggle (3).