Creating and configuring the Relay system object

You can create the Relay system object on the basis of the Video capture device object.

To create and configure the main parameters of the Relay object, do the following: 

1. Go to the Hardware tab of the Axxon PSIM settings panel (1).
2. Create the Relay object on the basis of the Video capture device object or select the corresponding object in the object tree on the Hardware tab of the Axxon PSIM settings panel (2).
   

3. When you create the Relay object (3), you must specify the ID, the name of the object and select the Video capture device object based on which the Relay object is created.

   Note

   If you use the sensor-relay card, then in the Relay object settings, you must specify the video capture card on the ADC of which the sensor-relay card is installed.

4. Select the channel number in accordance with the number of the output connector to which the relay is connected physically (4).

5. In the Executor drop-down list, select the type of the executive device used as the relay on the protected facility (5).
   The Executor parameter is used for selecting the icon that is displayed on the interactive map. This parameter is required for the better perception of information by the operator that is displayed on the map as object icons, as well as for the rapid operator reaction if such is required.
   The types of executive devices available for the Relay system object are given in the table.

   Executive  device	Description
   Light	The icon of the interactive map for the device responding to changes in the illumination on the protected facility
   Signal	The icon of the interactive map for the device responding to the background sound changes on the protected facility
   Lock	The icon of the interactive map for the device that responds to locking/unlocking a window, door, and so on

6. Click the Apply button to save the changes.

Creating and configuring the Relay object is complete.