Documentation for Axxon PSIM 1.0.0-1.0.1.

Previous page Connecting SL USBIO cards (4x4, 16x8 and 24x4)  Connecting AGRG-IO-16/8-WD-DS Sensor-Relay cards Next page


The MO USBIO 4x4 card is an interface of external sensors and external executive devices (relays) as a part of video surveillance and fire and security alarm systems.

The figure shows the appearance of MO USBIO card. 

Note

This card can be bundled as an external module – see the Connecting MO USBIO 4x4 external module section


The layout of card connectors:

The device is controlled via the USB interface. Electrical and technical specifications of the card are given in the Electrical and technical specifications of MO USBIO 4x4 section.

Connect the MO USBIO 4x4 card to the Server as follows:

  1. Switch the computer power supply off. Remove the system cover.
  2. Install the MO USBIO 4x4 card into a vacant motherboard slot and fix it in the casing.
  3. Connect the loop (bundled with the distribution kit) to the J1 connector and to a vacant USB connector on the motherboard of computer .
  4. To connect sensors and relays unsolder the connector bundled with the distribution kit. Unsoldering is made in accordance with the external connector pinout of the MO USBIO 4x4 card.
  5. Fix the unsoldered connector in the casing bundled with the distribution kit.
  6. Connect ready-for-use connector to external connector of the card in order to connect sensors and relays to the Server.

The MO USBIO 4x4 card is now connected.