Documentation for ACFA PSIM 1.3.

Previous page Viewing the Connection Parameters of a HID Integration Module's Controller  Configuring the priority for class codes of messages Next page

To configure a controller's EEPROM limits, go to the setup panel of the controller's object and click EEPROM Address assignments.

The EEPROM Address Assignmentswindow opens.

To configure the EEPROM limits:

  1. If you want to configure the EEPROM, select the EEPROM programmed checkbox (1).
  2. If the reset switch is enabled, select the Reset switch enabled checkbox (2).
  3. If the AC failure input is enabled, select the AC failure input enabled checkbox (3).
  4. If the tamper switch is enabled, select the Tamper switch enabled checkbox (4).
  5. If the battery failure input is enabled, select the Battery failure input enabled checkbox (5).

  6. To set the limits for each of the above switches/inputs, go to the relevant parameter group.

    Parameter

    Description

    HRUL

    High Range Upper Limit

    HRLL

    High Range Lower Limit

    LRUL

    Low Range Upper Limit

    LRLL

    Low Range Lower Limit

  7. In the AC failure input debounce time, msec field, enter the time period (in milliseconds) to be used for fixing (debouncing) the bouncing AC failure input signal (6).
  8. In the Tamper switch debounce time, msec field, enter the time period (in milliseconds) to be used for fixing (debouncing) the bouncing tamper switch signal (7).
  9. In the Battery failure debounce time, msec field, enter the time period (in milliseconds) to be used for fixing (debouncing) the bouncing battery failure input signal (8).
  10. Click OK to save the changes. This also brings you back to the setup panel (9).

Note:

To come back to the setup panel without saving the changes, click Cancel (10).

The EEPROM limits are now configured.