Documentation for ACFA PSIM 1.3.

Previous page Configuring the controller MAC address  Configuring a V2000 controller's door behavior Next page

To configure a controller's messages, go to the setup panel of the relevant object.

To configure the messages:

  1. If you want to record, in the Event log, messages about the fact that the connection to the controller is established successfully and that the controller is available, select the Use HereIAm checkbox, go to the Interval, sec field and enter the time interval (in seconds) between two consecutive messages (1).

  2. If you want to send the same messages to the HID Server, select the Use Heartbeat checkbox, go to the Interval, sec field and enter the time interval (in seconds) between two consecutive messages(2).

    Note:

    We recommend using HereIAm messages (to enable, select the Use HereIAm checkbox).
  3. In the Heartbeat message field, enter the vendor-defined value(3).

The messages are now configured.