Documentation for ACFA PSIM 1.3.

Previous page Configuration management of the PIDs Fiber Sensys  Working with the Fiber Sensys integration module Next page

The Fiber Sensys APU channel is configured as follows:

  1. Go to the settings panel of the Channel object.
  2. In the Gain (1) field, specify the overall sensitivity of the system. A higher value means a higher sensitivity.
  3. Use the Enable wind rejection drop-down list (2) to enable or disable wind rejection function. If this parameter is enabled, the APU will track the effect of wind on the channel and compensate for it based on the detected load.
  4. In the Comb Reject Filter (db) [1 to 300] (3) field, specify the signal gain in decibels to implement the comb filter.
  5. In the Sensitivity Factor [1 to 100] (4) field, specify the gain of the dry signal from the protected area. Typically used to increase the amplitude of a signal in spectrum view to improve signal visibility.
  6. If XML mode is enabled, in the XML report interval (0.1s) [1 to 600] (5) field specify the maximum frequency in seconds for outputting XML reports.
  7. Use the Enable CPU-1 drop-down list (6) to enable or disable processor 1 (climb detection).
  8. Use the Enable CPU-2 drop-down list (7) to enable or disable processor 2 (cut detection).
  9. Click the Apply button (8).
  • No labels