Previous page Configuring the Suprema 2 access point  Configuring the Suprema 2 slave controller Next page


The Suprema 2 reader is configured as follows:

  1. Go to the Suprema 2 Reader object settings panel. The object is created on the basis of the Suprema 2 Host object.
  2. In the ID (1) field, specify the identification number of the reader.
  3. From the Region in (2) drop-down list, select the Region corresponding to the area where the user will be located after entering.

  4. From the Region out (3) drop-down list, select the Region corresponding to the area where the user will be located after exiting.

    Note

    The Region in and Region out fields should be selected if Time and Attendance interface module is used. Otherwise, leave these fields empty.

  5. Configure sending an event upon successful access: Swap pass/granted (4). If the checkbox is cleared, the Pass event is generated, otherwise, the Access granted event is generated.
  6. Click the Apply (5) button to save changes.

Configuring the Suprema 2 reader is completed.

  • No labels