Documentation for ATM Intellect 13.0. Documentation for other versions of ATM Intellect is available too.

Previous page ATM-Intellect Pro configuration  Configuration of the ATM-Intellect Pro object Next page

Attention!

Every time when ATM-Intellect Pro starts, it checks for a Backup folder at the root of the disk on which Intellect software is installed. This folder is created if it does not exist already. It is forbidden to delete this folder. 

Note

ATM-Intellect components (ATM-Intellect Pro and ATM-Intellect Workstation) can work in a distributed configuration, while all the listed objects see where each of them is installed and can be configured.

To create necessary ATM-Intellect Pro objects, do the following:

  1. Go to the Hardware tab of the System settings dialog box.
  2. Create the IIDK Interface object (1). Set the identifier of the IIDK Interface object (2).
  3. Create the ATM-Intellect Pro object based on the Computer object (1). On the settings panel of this object, in the IIDK interface field (2), enter the identifier of the previously created IIDK Interface object.

  4. Create the required number of child Surveillance Object objects on the basis of the ATM-Intellect Pro object.

    Note

    The Surveillance Object object name cannot contain the following characters: underscore "_", backslash "\", angle brackets ">" and "<", single quote "'".

You also need to create Video Capture Device, Camera and Sensor objects corresponding to the connected equipment. Creation and configuration of these objects is described in the INTELLECT Software Package. Installing and configuring security system components.

Objects creation is completed.