Documentation for Auto Intellect 5.5. Documentation for other versions of Intellect is available too.

Previous page Joint operation of the LPR channel and Speed traps server modules  Selecting the traffic direction for LP number recognition Next page


By default, the LPR channel scans the whole video image received from the camera for the LP number. To decrease the CPU load, a smaller area where the LP should be searched for, can be specified.

Note.

This setting can be configured only when Auto-Uragan, CARMEN-Auto, ARH-Containers, VIT, IntLab, or IntelliVIsion LPR program modules are used (see Activating the program module, used for identifying the plates).

Note.

If the LP search area border is specified, only the LPs that completely fit into the area will be recognized.

Note

To ensure the correct LP recognition, camera captions should not overlap the LP search area.

The search area borders can be specified using one of two methods:

  1. Manual entry of the area coordinates;
  2. Pointing at the borders on the video image using the mouse.

To manually enter the exact values of the search area borders, do the following:

  1. Go to the LPR channel object settings panel, corresponding to the activated module (see Activating the program module, used for identifying the plates section).
  2. Check the Search area checkbox (1) to enable specifying the search area borders.
  3. In the Left, Top, Right, and Bottom fields (2), specify the required values. These values correspond to the search area borders percentage of the full frame size.
    To specify the search area borders using the mouse, do the following:
    1. Click the  (2) button. The Search area border, % window will appear. In this window, do the following:
    2. left-click and hold the mouse button on the video image at one of the corners of the supposed search area;
    3. keep the mouse button pressed and drag the pointer across the supposed search area to the opposite corner;
    4. release the mouse button;

    5. click the OK to save the selected area.

      Note

      With the use of VIT software module, you can specify search area borders of any shape.

      To specify non-rectangular search area borders, set the anchor points of the required shape with the left mouse button. After you set the last anchor point, click the right mouse button, and the shape will automatically close.

  4. Click Apply (3).

The LP search area border is now set up.

  • No labels