Documentation for Auto Intellect 5.5. Documentation for other versions of Intellect is available too.

Previous page Selecting the traffic direction for LP number recognition  Frame processing setup Next page


To set up the detector parameters, do the following:

  1. Go to the settings panel of the LPR channel object corresponding to the activated software module (see Activating the program module, used for identifying the plates).

    Note

    Parameters availability depends on activated software modules (for details, see The LPR channel object settings panel).

  2. Enter the value in the Area search threshold field (1).

  3. Set the Max. width and Max. height parameters:

    1. Click the  (2) button next to the parameters. Interactive interface of setting up the zone parameters showing the image from the corresponding camera will be displayed.

    2. At the appropriate moment, click the Stop video button and then hold the mouse while dragging it across the required area and click OK button.

      Note.

      You can select the zone in the Real Time Video mode as well. 

      Results of setting the parameters will be automatically entered in the Max. width and Max. height fields.

      Note

      It is not recommended to set maximum sizes greater than required, as this slows down the processing, but does not improve the quality of recognition.

  4. Set the Min. width and Min. height parameters by analogy with Max. width and Max. height parameters using the  button (3).

  5. If necessary set the Cut image with vehicle checkbox (4).

    Note.

    The Cut image with vehicle option is used only when working with megapixel video surveillance cameras.

  6. Click Apply button (5).

The LPR channel settings are now completed.

  • No labels