Documentation for Auto Intellect 5.6. Documentation for other versions of Intellect is available too.

Previous page Setting up the frame sign parameters  Setting the joint operation of the LPR channel and the motion detector of the Intellect platform Next page


The LP numbers of passing vehicles are automatically identified and subsequently shown in the LPR channel. By default the identified number is displayed after the vehicle leaves the camera viewing zone.

Note.

This setting is specified only if AUTO-Uragan, VIT or CARMEN-Auto software modules are in use.

The AUTO-Uragan module can be set to recognize and show the LP number before the vehicle leaves the camera viewing zone.

If the LP number should be shown before the vehicle leaves the viewing zone, do the following:

  1. Go to the LPR channel object settings panel, corresponding to the activated module (see Activating the program module, used for identifying the plates section).

  2. Set the Show results before vehicle leave checkbox (1) to show the result before the car actually leaves the viewing zone (more precisely, before the license plate leaves the recognition zone). If the checkbox is not set, the result will be shown only after the car actually leaves the zone.

  3. In the Delay of showing results field (2), specify the time in seconds, after which the recognition result will be displayed. This period of time starts after the first LP recognition.

    Note.

    This parameter is enabled if the Show results before vehicle leave checkbox is checked.

  4. In the Recognition number threshold field (3), specify the number of reliable license plate recognitions, upon reaching which the recognition result will be displayed. The recognition number counter is cumulative and is not reset in case of temporary loss of a given zone or false recognitions.

    Note.

    This parameter is enabled if the Show results before vehicle leave checkbox is checked.

  5. Click Apply (4).

Note.

If both Delay of showing results and Recognition number threshold fields are set, the results will be shown upon the event that occurs first (either the time delay elapses, or the number of recognitions is reached). If the values of these parameters are set to 0 or not set at all, then these parameters are not taken into account, and the LP recognition results will be shown after the car leaves the viewing zone.

Note.

Show results before vehicle leave, Delay of showing results and Recognition number threshold parameters don't work with the Parking mode.

 The LP recognition results display is set up.

  • No labels