Documentation for DetectorPack PSIM 1.0.1.

Previous page Camera requirements for the Barcode detection module  Equipment detection (PPE) Next page

The Barcode detection module can be configured using the System settings menu, on the Hardware tab, on the Barcode detection settings panel, using the Camera settings.

The Barcode detection module is configured as follows:

  1. Go to the Barcode detection settings panel.
  2. From the Captioner drop-down list, select the captioner with the help of which result will be displayed in the monitor (1)

  3. In the Skip repeated recognitions, s field, enter the time in seconds in which the repeated code is recognized (2).

    Note

    If there are different barcodes or QR-codes one after another, the recognition is performed instantly. If there are repeated barcodes, the new result will be displayed after the time period specified in the settings.

  4. Click the Settings button (3). The Detection settings window will open.
  5. Specify the detection surveillance area:
    1. Click the Stop video button to capture the video image (1).
    2. Click the Area of interest button (2).

    3. On the captured video image, specify areas to be analyzed. It is possible to add only one area. When attempting to add the second area, the first one will be deleted. After area specifying, the remaining part of video image will be darkened.

      Note

      To remove the area, click the button next to the Area of interest button.

      Attention!

      Barcode can be detected not only when the entire barcode or QR code is within the specified area, but also only a fragment of it.

    4. Click the OK button (3) to save the changes and return to the settings panel of the Barcode detection.

      Note

      To return to the settings panel of the Barcode detection without saving the changes, click the Cancel button.

  6. On the Barcode detection settings panel, click the Apply button (4).

Configuring the Barcode detection module is complete.

  • No labels